Filter
Top Products
DTP HDMI 230 & 330 D Transmitter and Receiver • Installation and Operation 6
Final Installation
After testing and making any adjustments, do the following:
1. At the power outlet, unplug the power supply.
NOTE: One power supply can power both the transmitter and the receiver (see
Power Supply Wiring on page 11 and Ground Loops on page 14).
2. Mount the transmitter or receiver into the wall box or mud ring, and attach the supplied
Decora faceplate to the unit (see figure 2 on page 4).
3. At the power outlet, reconnect the power supply. This powers up both units.
Transmitter Connections
Transmitter Front Panel
INPUTS
AUDIO
Tx Rx GTxRx
RS-232 IR
OVER DTP
C
B
A
Figure 4. DTP HDMI 230 & 330 D Transmitter Front Panel Connectors
A HDMI input connector — Connect an HDMI cable between this port and the HDMI
output port of the digital video source.
B Audio input — Connect an unbalanced stereo audio source to this 3.5 mm mini stereo
jack. Figure 5 shows how to wire the audio plug.
Sleeve ( )
Ring
Right (
-
)
Tip
Left (+)
Figure 5. Audio Input Connector Wiring