Filter
Top Products
DTP HDMI 230 & 330 D Transmitter and Receiver • Installation and Operation 8
Receiver Connections
Receiver Rear Panel
SIG
LINK
DTP IN
POWER
12V
0.8 A MAX
DTP 230/330 D Rx
B
A
Figure 7. DTP HDMI 230 & 330 D Receiver Rear Panel Connectors
A Receiver input ports — Connect the opposite end of the twisted pair cable from the
transmitter output connector (see
B
on the previous page) to this RJ-45 connector
(see TP Cable Termination and Recommendations on page 10 to properly wire the
RJ-45 connectors).
ATTENTION: Do not connect this device to a telecommunications or computer
data network.
B DC power input connector — Plug the included external 12 VDC power supply
into either this 2-pole connector (see Power Supply Wiring on page 11 to
wire the power connector) or the power input connector on the transmitter (see
A
on the previous page).