Filter
Top Products
ENGLISH
37
TROUBLESHOOTING
Symptoms That Seemingly Appear to be Failures
Make the checks suggested below depending on the symptoms observed. If the symptoms remain uncorrected, contact
your dealer.
Symptom Point to check See page
• No picture with the power-indicating
lamp off.
• Check the way the power cord is connected.
• Press the power switch.
23
24
• The message “No Input Signal. Going to
suspend” or “Power Save” is displayed.
• No picture with the power indicating lamp
lights in orange.
No input signal is detected.
• Check the way the signal cable is connected.
• Make sure that the switch of the computer, imaging
equipment, etc., is turned on.
• Make sure the computer is not in the power-save mode.
• Check to see if the input selection matches the connection
terminal.
22
• The message “No Input Signal. Going to
sleep” is displayed.
An input signal is not received normally.
• Check to see if the input signal matches the
specifications.
• Check the way the signal cable is connected.
22
40
• The power indicating lamp is normally lit
but no picture.
• Check the contrast and brightness settings (adjust them for
higher contrast and brightness).
• Check the way the signal cable is connected.
19
28
• The display image appears flowing
slantwise.
• Text displayed across the screen
appears vertically streaked, with the
characters in vertical columns blurred.
• Adjust the dot clock frequency and phase. (Adjust the dot
clock frequency first, the dot clock phase next.)
(PC RGB input)
29
41
• Text displayed across the screen
appears blurred.
• A fine pattern flickers when displayed on
the screen.
• Adjust the dot clock phase for the clearest viewing.
(PC RGB input)
29
41
• The remote control does not work.
• Check to see if the batteries are loaded in the remote
control in opposite direction.
• Check to see if the batteries in the remote control are OK.
11
• The display image does not appear in
the normal position.
• Check to see if the displayed input signal match the PDP
TV specification by pressing RECALL button.
• Turn off the Move screen.
31
40
• The display has lack of picture around
the screen.
(PC RGB input)
• Turn off the Move screen.
31
• The temperature of the display panel surface is high. • The plasma display panel is lighting the phosphors by the
discharge of internal radiation. In some cases, this may
cause the temperature of the panel surface to increase.
Please note that this is not a malfunction.
-
Customer servicing can be hazardous.
No Input Signal
No Input Signal
HITACHI MODEL 42PD6000TA
Downloaded From TV-Manual.com Manuals