Filter
Top Products
DESCRIPTION
The BassLink 4sc is a plug-and-play amplifier
designed to make upgrading your system easy.
The BassLink 4sc is designed to slide into an
available slot in the BassLink II. Unlike an
additional outboard amplifier, the BassLink 4sc
doesn’t require any additional space. The
BassLink 4sc also includes a Phantom Center
effect, which creates the illusion of a center
channel even if no center speaker is installed.
INSTALLATION
1. Remove the wiring cover from BassLink II.
2. Remove the eight screws that hold the
AMPLIFIER DOCK cover panel in place
(Figure 9). Save the screws.
3. Remove the screw that attaches the two
wiring harnesses and connectors to the panel.
4. Connect the wiring harness connectors to the
appropriate connectors on the BassLink 4sc’s
circuit board. See Figure 10.
5. Insert the amplifier and install the eight
screws that were removed in Step 2. See
Figure 10.
6. Install 40A fuse at the battery.
Note: All four inputs on BassLink II must be used
in order for the BassLink 4sc amplifier to function
properly.
Figure 9.
Figure 10.
BASSLINK 4SC INSTALLATION
CONNECTIONS
Connect the front and rear speakers as shown in
Figure 11.
Figure 11.
SETTINGS
The BassLink 4sc has input level control for the
front and rear speakers and PHANTOM CENTER
controls.
For proper setup, please refer to the full
BassLink 4sc owner’s manual.
Figure 12.
APPLICATION
Figure 13. Typical installation using all four speaker-
level inputs from the source unit.
Left Front Right
Left Rear Right
+
– –
– –
+
+
+
Left Front Right
Left Rear Right
+
– –
– –
+
+
+
BassLink II
(right side)
LF
+
–
RF
–
+
LR
+
–
RR
–
+
Powered Subwoofer Basslink II
5