Filter
Top Products
14
Insignia NS-A1000 Car Stereo Amplifier
www.insignia-products.com
Troubleshooting
Before removing your amplifier, locate the problem in the following
table. Always test the speakers and speaker wires before
troubleshooting the amplifier.
Symptom Check Solution
No sound Is the power
indicator LED
lit?
• Check the amplifier fuses.
• Make sure that the remote turn on wire is
connected.
• Check the signal leads.
• Check the gain control.
• Check the source volume level.
• Clean the contacts on the fuse holders.
Is the fault
LED lit?
• Check for a speaker short circuit,
amplifier overheating, or low voltage.
The amplifier
will not turn on
Is there power
to the power
wire?
• Make sure that the amplifier has a good
ground connection.
• Repair the power wire or the
connections.
Is there power
to the remote
turn on wire
with the
receiver on?
• Check the connections to the +12 V
source.
Is there a
blown fuse?
• Change the fuse.
No sound on
one channel
Check the
speaker leads.
• Check for a short circuit or open
connection. Repair if found.
Check the
Audio input
leads.
• Reverse the left and right inputs to
determine if the fault is occurring before
the amplifier.
The amplifier
is turning off at
medium to
high volume
levels
Check the
speaker load
impedance.
• Make sure that the correct speaker load
impedance recommendations are
followed.
• Check the speaker resistance with an
ohmmeter.
The protection
LED is on
(Red)
Is the amplifier
very hot?
• Turn off the source unit and wait until the
amplifier cools.
Is there a short
in the speaker
wires?
• Separate and insulate the speaker wires.