Filter
Top Products
14
NS-C5111 Car Deck
www.insignia-products.com
3 Gently press the front panel into the notches.
4 Swing the front panel up to close your car deck.
Removing your car deck
To remove your car deck:
1 Make sure that the car ignition is turned off, then disconnect the
negative cable from the car battery.
2 Remove the metal strap from the back of your car desk (if
attached).
3 Press the release button to open the front panel, then remove the
front panel.
4 Lift the top of the outer trim ring, then pull it out.
5 Insert the release keys into the slots on the middle right and left
sides of your car deck, then pull your car deck out of the
dashboard.
Using your car deck
Turning your car deck on and off
To turn your car deck on and off:
1 Press the
PWR button on your car deck or the POWER button on
your remote control to turn on your car deck.
2 Press and hold the
PWR button on your car deck or the POWER
button on your remote control for two seconds to turn off your car
deck.
Adjusting the volume
To adjust the overall volume:
• Turn the volume knob on your car deck left or right or press the
VOL down or up button on your remote control to decrease or
increase the volume.
To adjust the initial volume:
1 Press the function select button on your car deck or press the
SEL
button on your remote control for more than two seconds.
2 After you enter setup mode, press and release the function select
or
SEL button until IN VOL appears on the display.
Caution
Do not press the front panel too hard against your car deck, and do
not press the LCD screen. You may damage the screen.
Note
The initial volume is the volume level your car deck uses each time
you turn on your car deck.