Jensen MPX6411 Car Stereo System User Manual


 
MPX6411
9
TUNER OPERATION
The MPX6411 comes equipped with a World Tuner, allowing you to receive channels in USA,
EUROPE, LATIN, & OIRT (Russia). See “Frequency Spacing” on page 7 to learn how to
change the World Tuner options.
Select a Band
Press BAND (19) to change between three FM bands and two AM bands. Each band stores up
to six preset stations.
Tuning
Manual Tuning
Press the UP TUNING (10) or DOWN TUNING (11) button for more than three seconds to
enter manual tuning mode, then press the UP TUNING or DOWN TUNING buttons to move the
radio frequency number up or down one step.
Auto Seek Tuning
Press the UP TUNING (10) or DOWN TUNING (11) button for less than three seconds to move
to next station automatically.
Scan
Press SCAN (20) to scan through strong stations in the current band. The radio pauses for five
seconds at each strong station. Press SCAN again to listen to the current station.
Preset Stations
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Hold a preset button (12-17) for three seconds.
The preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (12-17) to select the corresponding stored
station.
Automatically Store / Preset Scan
Automatically Store
Automatically select six strong stations and store them in the current band. Select a band (if
needed). Press AS/PS (21) for more than three seconds. The new stations replace any
stations already stored in that band.
Preset Scan
Scan stations stored in the current band. Select a band (if needed). Press AS/PS (21) for less
than three seconds. The unit will pause for ten seconds at each preset station. Press AS/PS
again to stop scanning when the desired station is reached.
Stereo
The unit will automatically pick up a stereo signal, when available. When in stereo mode, the
“ST” icon (18) appears in the display. When no stereo signal is available, the unit will
automatically revert to mono operation, and no icon will be displayed.