Jensen MPX6411 Car Stereo System User Manual


 
MPX6411
2
PREPARATION
Tools and Supplies
The following tools and supplies are needed to install the radio.
Torx type, flathead and Philips screwdrivers
Wire cutters and strippers
Tools to remove existing radio (screwdriver, socket wrench set or other tools)
Electrical tape
Crimping tool
Volt meter/test light
Crimp connections
18 gauge wire for power connections
16-18 gauge speaker wire
SPEAKER REQUIREMENTS: Only connect speakers rated in the load impedance of 4
ohms. Speakers with a load impedance less than 4 ohms could damage the unit.
Pre-installation
1. Disconnect Battery
Before you begin, always disconnect the battery negative terminal.
2. Remove Transport Screws
3. Remove Radio from Sleeve
Lift latches on both sides of sleeve to remove half-sleeve from radio.
TRANSPORT
SCREWS
HALF
SLEEVE