Filter
Top Products
VM8013HD
3
WIRING
(Yellow)
(Yellow)
(Blue)
(Yellow)
Purple
Purple/Black
Stripe
Gray
Gray/Black
Stripe
White/Black
Stripe
White
Green/Black
Stripe
Green
Left Speaker
(Front)
Right Speaker
(Front)
Left Speaker
(Rear)
Right
Speaker
(Rear)
Blue
Red
Front Line out
R (Red)
L (White)
Black
Power Antenna
Connect to power antenna or amplifier.
If not used, tape bare end of wire.
Accessory/Ignition
Connect to existing radio wire
or radio fuse.
Rear Line out
R (Red)
L (White)
Gray
Yellow
Black
Subwoofer Out
Parking Brake
(Pink)
Camera In
SAT R (Red)
Video Out 1
SAT L (White)
Video Out 2
Fuse (15A)
Camera/Active High Level Input (Green/White)
SWC (Steering Wheel Control)
Chassis Ground
Battery
)
-
()
(
+
Connect the black wire to the factory ground wire. If a
factory ground wire is not provided, locate a clean,
unpainted metal part of the dash and secure the ground
wire with a "ring" terminal and a sheet metal screw.
Connect the yellow wire to the battery
or 12 volt power source that is always
live. This wire MUST be connected
for the radio to work.
SAT BUS
IPOD BUS
FILTER
BOX
Satellite Radio Tuner
(sold separately)
JXMC or XMDJEN100 Cables
(sold separately)
IMPORTANT!
The pink parking
wire MUST be
connected to the
switched side of the
parking break
circuit (the part that
becomes grounded
when the brake is
applied).
iPod
(Sold Separately)
FRONT
REAR
Antenna
jLink iPod Cable
(Included)
(Requires PAC SWI-PS InterfaceAdapter)
+
NOTE: Video playback not supported for all
iPods. See iPod section for more information.
NOTE: The amplifier in this radio is only designed for use with four
speakers. Never combine (bridge) outputs for use with two
speakers. Never ground negative speaker leads to chassis ground.
NOTE: Only connect speakers with a nominal impedance
of 4 ohms. Speakers with a load impedance less than 4
ohms could damage the unit.