Jensen VM8023HD Car Video System User Manual


 
VM8023HD
6
OPERATION
Power
Press the (power) button (1) to turn the unit on. Press and hold the power
button again to turn the unit off.
NOTE: LCD panels may take longer to respond when subjected to cold
temperatures for an extended period of time. In addition, the visibility
of the numbers on the LCD may decrease slightly. The LCD display
will return to normal when the temperature increases to a normal
range.
Source
Press the SRC button (6) repeatedly to scan the various sources. A source
is only displayed when accessible (optional equipment required for some
sources). Available modes include Radio (FM, AM), SAT, DVD, SD, USB,
iPod and auxiliary (AUX IN).
External Devices
External peripheral devices, including a game console, camcorder,
navigation unit, iPod, Zune, etc. can be connected to the A/V connector (18)
on the front of this unit using the 3.5mm Media Cable (included). Select
“SOURCE >> AUX IN” to access auxiliary devices. You cannot directly
control external devices connected to the A/V IN inputs.
Audio Mute
Press the (power) button (1) to silence the audio volume. “ ” appears
on the display. Press (power) again to restore volume to the previous
setting.
Volume Control
To increase the volume, turn the VOL/SEL/MENU (rotary encoder) (2)
clockwise. To decrease the volume, turn the rotary encoder counter-
clockwise. When volume is adjusted, the volume level will be shown on the
display panel as a number ranging from “0” (lowest) to “40” (highest).
Steering Wheel Control (SWC)
The VM8023HD is compatible with the PAC (Pacific Accessory Corporation)
steering wheel control adapter SWI-PS. A 3.5mm female connector
(labeled “SWC Interface”) on the back of the head unit allows connectivity to
the PAC adapter. Please refer to the instructions included with the PAC
adapter for detailed installation information.
The following controls are available for most vehicles:
1. Vol Down
2. Vol Up
3. Mute
4. Seek Down / Previous Track
5. Seek Up / Next Track
6. SRC (Source)
7. Band
Audio Menu
Press the VOL/SEL/MENU button (2) to access the audio menu. Press the
VOL/SEL/MENU button repeatedly to move through the list of menu
options.
Sub_w: When the Low Pass Filter is activated (see “Menu Operation”
on page 7), you can use the VOL/SEL/MENU rotary encoder to adjust
the subwoofer volume from “-14” to “0”.
Bass: Turn the VOL/SEL/MENU rotary encoder (2) to adjust the bass
level from “+7” to “-7”.
Treble: Turn the VOL/SEL/MENU rotary encoder to adjust the treble
level from “+7” to “-7”.
Balance: Turn the VOL/SEL/MENU rotary encoder to adjust the
balance from “R7” (full right) to “L7” (full left).
Fader: Turn the VOL/SEL/MENU rotary encoder to adjust the fader
from “F7” (full front) to “R7” (full rear).
The unit automatically saves your changes and exits the audio control menu
after five seconds of inactivity.
NOTE: This model is equipped with source tone memory. Any
changes to the Bass, Treble, and Sub-w are reflected only in the active
source.