Jensen VM8023HD Car Video System User Manual


 
VM8023HD
3
WIRING
IMPORTANT!
The pink parking wire MUST
be connected to the switched
side of the parking break
circuit (the part that becomes
grounded when the brake is
applied).
Fuse (15A)
(Blue)
(Yellow)
PARKING
(Yellow)
(Yellow)
VIDEO OUT 1
VIDEO OUT 2
SUB (Subwoofer) OUT
R (Red)
R (Red)
L (White)
L (White)
Pink
Amplifier
REAR Line Out
FRONT Line Out
CAMERA IN
Purple
Purple/Black
Stripe
Gray
Gray/Black
Stripe
White/Black
Stripe
White
Green/Black
Stripe
Green
Left Speaker
(Front)
Right Speaker
(Front)
Left Speaker
(Rear)
Right
Speaker
(Rear)
Blue
Red
Power Antenna
Connect to power antenna
or amplifier. If not used,
tape bare end of wire.
Accessory/Ignition
Connect to existing radio
wire or radio fuse.
Yellow
Black
SWC (Steering Wheel Control)
Chassis Ground
Battery
)
-
()
(
+
Connect the black wire to the factory ground wire. If a
factory ground wire is not provided, locate a clean,
unpainted metal part of the dash and secure the ground wire
with a "ring" terminal and a sheet metal screw.
Connect the yellow wire to the battery or
12 volt power source that is always live.
This wire MUST be connected for the
radio to work.
FILTER
BOX
iPod
(Sold Separately)
FRONT
REAR
(Requires PAC SWI-PS InterfaceAdapter)
CAMERA (Active High Level Input)
+
(Green/
White)
SAT BUS
IPOD BUS
Satellite Radio Tuner
(sold separately)
JXMC or XMDJEN100 Cables
(sold separately)
jLink/jLink iPod Cable
(Included)
SAT R (Red)
SAT L (White)
2
NOTE: The amplifier in this radio is only designed for use with four
speakers. Never combine (bridge) outputs for use with two
speakers. Never ground negative speaker leads to chassis ground.
NOTE: Only connect speakers with a nominal impedance
of 4 ohms. Speakers with a load impedance less than 4
ohms could damage the unit.