JL Audio 011180 Car Speaker User Manual


 
➔➔
➔➔➔
STEP 7: Slide the center console to the rear of
truck.This will allow exposer of the 12v plug wires.
Unplug and then remove the center console from
truck.
*Tundra Access Cab Only*
Keep the air ducts inside the truck, for now.
STEP 11: Back inside the truck. Remove the black
bracket that is mounted to the floor of the
truck(not pictured).
*Tundra Access Cab Only*
Using a 1/2” drill bit and drill. Enlarging the mounting
holes from the bracket.
Cont.
From
Previous
Page
Continued on Next Page
STEP 8: *Tundra Access Cab Only*
With the center console out of the truck, flip up
side down. Remove the two air duct ears that are
located to the rear of the center console.
*Tundra Access Cab Only*
STEP 12: Cut 1-1/2” off of each carpet flap, that is
located in front of the mounting holes, from
STEP10.
*Tundra Access Cab Only*
STEP 13(a): Place only one of the supplied wax
squares into this location.
Place the middle of the supplied wax square, 4-3/4”
back from the front consoles metal mounting brack-
et.
*Tundra Double Cab Only*
STEP 13(b)
FRONT WAX SQUARE
Place the middle of one of the supplied wax
squares, 4-3/4” back from the front consoles metal
mounting bracket.
REAR WAX SQUARES
Place the middle of the remaining pair of supplied
wax squares, 1-3/4” back from the center console
rear mounting holes.
STEP 9: Remove the 8 screws that is securing
the black plastic support to the outer console. Not
all circles represent all 8 screws.
There are a pair of screws on each side of the con-
sole that need to be removed.
STEP 10: *Tundra Access Cab Only*
Now it is time to remove those air ducts from
STEP 7.With the ducts removed, you will need to
cut both ducts. Place the ducts so the front of the
ducts are facing to the right.
Driver’s side: Measure and mark 3/4” from front
of foam tape, back. Cut at location.
Passenger’s side: Cut at the middle of the foam
tape.
SB-T-TUNCNSL2/10W3v2, JL AUDIO, Inc 2005
Sheet SKU#011180 Revision 4/6/2005Page 2
www.jlaudio.com
Passenger’s side
middle
Driver’s side
3/4”
4-3/4”
6-1/2”
1-3/4”