JL Audio 011180 Car Speaker User Manual


  Open as PDF
of 5
 
➔➔
➔
Cont.
From
Previous
Page
Continued on Next Page ➔
➔
STEP 14: Thread in the three supplied socket cup
set screws into the Stealthbox. Make sure that the
socket ends are on the outside of the Stealthbox.
The rear(left side of pic) threaded rods need to
protrude about 1 1/4” out of the Stealthbox.The
front socket cup set screw needs to protrude about
3/4”.
Place the Stealthbox into location. Slide the rear
socket cup set screw through the drilled out holes
from STEP10. Press firmly on the front of the
Stealthbox, marking the wax square.
STEP 16(a): *Tundra Access Cab Only*
Remove the Stealthbox.You should have an impres-
sion on the wax square.
*CAUTION*
Before drilling, make sure that you are not going to
be drilling into any gas lines, brake lines, transmission
lines, electrical wiring, transfer case(4x4 vehicles) or
anything else that might cause a reduction in your
weekly pay. Always wear eye protection when drilling.
With the use of a 1/2” drill bit and drill. Drill out the
floor at the impression on the wax square
STEP 16(b): *Tundra Double Cab Only*
Remove the Stealthbox.You should have an impres-
sion on the wax square.
*CAUTION*
Before drilling, make sure that you are not going to
be drilling into any gas lines, brake lines, transmission
lines, electrical wiring, transfer case(4x4 vehicles) or
anything else that might cause a reduction in your
weekly pay. Always wear eye protection when drilling.
With the use of a 1/2” drill bit and drill. Drill out the
floor at the impression on the wax square
SB-T-TUNCNSL2/10W3v2, JL AUDIO, Inc 2005
Sheet SKU#011180 Revision 4/6/2005Page 3
www.jlaudio.com
STEP 15: Place the Stealthbox into position, Press
down firmly.
 previous next