Filter
Top Products
Sheet SKU#011118 Revision 5/21/01SB-GM-BURB/10W3 - JL AUDIO, Inc 2001 • Page 3
STEP 10: Remove the Stealthbox from the vehicle. There should be
clear impressions in the wax squares.
STEP 11: Remove the bolts from the Stealthbox.
Before drilling check under the vehicle for any loose wires, fuel lines or other hazards in the
areas where holes are to be drilled.
STEP 12: Using the impressions in the wax squares as guides, drill a 1/2" diameter hole through the floor
pan of the vehicle, using the impression in each wax square as a guide. Stop the drill immediately after
penetrating the metal.
STEP 13: Remove the wax squares from the vehicle.
STEP 14: Cut 1" diameter holes in the carpet centered on the
1/2" diameter holes you drilled in STEP 13 to allow the threaded
inserts in the Stealthbox to contact the metal floor pan.
STEP 15: Run speaker wires to the Stealthbox mounting location, as shown. Be sure the wires will not be
pinched once the Stealthbox is bolted into position.