Filter
Top Products
36
ENGLISH
Symptoms Remedies/Causes
MP3/WMA playback
• Disc cannot be played back. • Use a disc with MP3/WMA tracks recorded in the format
compliant with ISO 9660 Level 1, Level 2, Romeo, or Joliet.
• Add the extension code <.mp3> or <.wma> to the file
names.
• Noise is generated. Skip to another track or change the disc. (Do not add the
extension code <.mp3> or <.wma> to non-MP3 or WMA
tracks.)
• A longer readout time is required (“READING”
keeps flashing on the display).
Do not use too many hierarchies and folders.
• Tracks do not play back in the order you have
intended them to play.
Playback order is determined when the files are recorded.
• Elapsed playing time is not correct. This sometimes occurs during play. This is caused by how the
tracks are recorded on the disc.
• “NO FILES” appears on the display. Insert a disc that contains MP3/WMA tracks.
• Correct characters are not displayed (e.g.
album name).
This unit can only display alphabets (upper case), numbers, and
a limited number of symbols.
CD changer
• “NO DISC” appears on the display. Insert a disc into the magazine.
• “NO MAGAZINE” appears on the display. Insert the magazine.
• “RESET 8” appears on the display. Connect this unit and the CD changer correctly and press the
reset button of the CD changer.
• “RESET 1” – “RESET 7” appears on the display. Press the reset button of the CD changer.
• The CD changer does not work at all. Reset the unit (see page 2).
Bluetooth
• Bluetooth device does not detect the unit. The unit can be connected with one Bluetooth cellular phone
and one Bluetooth audio player at a time.
While connecting a device, the unit cannot be detected from
another device. Disconnect currently connected device and
search again.
• The unit does not detect the Bluetooth device. • Check the Bluetooth setting of the device.
• Search from the Bluetooth device. After the device detects
the unit, select “OPEN” on the unit to connect the device (see
page 19).
• The unit does not make pairing with the
Bluetooth device.
• Enter the same PIN code into both the unit and the target
device. If the PIN code of the device is not indicated on its
instructions, try “0000” or “1234.”
• Select the device name from “SPECIAL,” then try to connect
again (see page 20).
EN_KDHDR30AHD39_f.indb 36EN_KDHDR30AHD39_f.indb 36 07.11.16 6:50:22 PM07.11.16 6:50:22 PM