JVC GET0063-001A Car Stereo System User Manual


 
11
ENGLISH
Playing the current tune repeatedly
You can play the current tune repeatedly (Repeat
Play).
1 Press MODE to enter the functions mode
while playing a tune you want to hear over
again on a cassette. This unit enters the
functions mode.
2 Press RPT (repeat), while still in the functions
mode, so that the RPT indicator lights up on
the display.
When the tune has been played, the tape is
automatically rewound to the beginning of that
tune and the same tune will be played again.
To cancel Repeat Play, repeat steps 1 and 2
again so that the RPT indicator goes off.
Note:
In the following cases, Blank Skip and Repeat Play
may not operate correctly:
–Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portions during
tunes.
–Tapes with short non-recorded sections.
–Tapes with high level noise or humming between
tunes.
–Tapes with tunes recorded at low recording levels.
Prohibiting cassette ejection
You can prohibit cassette ejection and can “lock”
a cassette in the cassette compartment.
Press and hold TAPE 23 and 0 for more than 2
seconds. “NO EJECT” flashes on the display for
about 5 seconds, and the cassette is “locked.”
To cancel the prohibition and “unlock” the
cassette, press and hold TAPE 23 and 0 for
more than 2 seconds again. “EJECT OK” flashes
for about 5 seconds, and this time the cassette is
“unlocked.”
Note:
If you press 0 while cassette ejection is prohibited,
the cassette will not be ejected.
Lights up when Repeat Play is turned on.
MODE
11
RPT
EN09-11KS-FX711/KS-FX511[U]f 3/1/02, 9:5211