Filter
Top Products
20
ENGLISH
Finding the beginning of a tune
Multi Music Scan allows you to automatically start
playback from the beginning of a specified tune.
You can specify up to 9 tunes ahead of or before
the current tune.
During playback
Specify where (how many tunes ahead of
or before the current tune) the tune you
want is located.
Each time you press the buttons, the number
changes up to ±9.
When the beginning of the specified tune is
located, playback starts automatically.
Notes:
• While locating a specified tune:
– If the tape is rewound to its beginning, playback
starts from the beginning of that side.
– If the tape is fast-forwarded to the end, it is
reversed and played from the beginning of the
other side.
• In the following cases, the Multi Music Scan
function may not operate correctly:
– Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portions
between tunes.
– Tapes with short non-recorded sections.
– Tapes with high level of noise or humming
between tunes.
– Tapes with tunes recorded at low recording levels.
– The Dolby NR setting does not match. For
example, if Dolby B NR is on and the tape was
recorded with no Dolby NR.
Press ¢ to locate
a tune ahead of the
current tune on the
cassette.
Press 4 to locate
a tune before the
current tune on the
cassette.
To play back tapes recorded with the
Dolby B NR*
1 Press MODE (M) to enter the functions mode
while listening to a tape.
“MODE” appears on the upper part of the
display, and the number buttons work as
different function buttons.
2 Press (Dolby B), while “MODE” is still on
the display so that the (Dolby B) indicator
lights up.
“DOLBY B” also appears on the display for
several seconds.
To cancel the Dolby B NR, repeat steps 1
and 2 above again.
*Manufactured under license from Dolby
Laboratories.
“Dolby” and the double-D symbol are
trademarks of Dolby Laboratories.
Prohibiting cassette ejection
You can prohibit cassette ejection and “lock” a
cassette in the cassette compartment.
Press and hold TAPE CD-CH and for
more than 2 seconds.
“NO EJECT” flashes on the display for about 5
seconds, and the cassette is “locked.”
To cancel the prohibition and “unlock” the
cassette, press and hold TAPE CD-CH and
for more than 2 seconds again.
“EJECT OK” flashes for about 5 seconds, and this
time the cassette is “unlocked.”
Note:
If you press 0 while cassette ejection is prohibited,
the display panel flips down, but the cassette continues
to play and cannot be ejected.
EN19-21KS-LH6R_LH4R[E]f.pm5 1/29/02, 9:56 AM20