Filter
Top Products
24
ENGLISH
• When “CEQ LINK” is set to “LINK ON”
The selected sound mode can be stored in
memory for the current source.
Each time you change to the same source, the
same sound mode is also recalled and shown
on the display. The C-EQ indicator also flashes.
• When “CEQ LINK” is set to “LINK OFF”
The selected sound mode effect applies to any
source.
Storing your own sound
adjustments
You can adjust the sound modes to your preference
and store your own adjustments in memory.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press MODE.
“MODE” appears on the lower
part of the display, and the
number buttons work as
different function buttons.
2
Press EQ (equalizer) while “MODE”
still on the display.
The last selected sound mode
is recalled and applied to the
current source.
3
Select the sound mode you want to
adjust.
Ex.: When you adjust “TRE”
To decrease the level.
To increase the level.
Equalization pattern
changes as you adjust
the bass or treble.
Ex.: If you have selected “ROCK” previously
Sound mode indicator flashes.
4
Select the item you want to adjust.
• See page 22 for details.
5
Adjust the level.
6
Repeat steps 4 and 5 to adjust the
other items.
7
Repeat the same procedure to store
other sound modes.
To reset to the factory settings, repeat the
same procedure and reassign the preset values
listed in the table on page 23.
EN22-24KD-SX927R[EE]f.pm5 14/02/2002, 10:17 AM24