Filter
Top Products
15
ENGLISH
Setting the TA volume level
You can preset the volume level for TA Standby
Reception. When a traffic programme is received,
the volume level automatically changes to the
preset level.
• See also “Changing the general settings
(PSM)” on page 22.
1 Press and hold SEL (select) for more than
2 seconds so that one of the PSM items
appears on the display.
2 Press ¢ or 4 to select “TA VOL”
(volume).
3 Press + or – to set to the desired volume.
You can set it from “VOL 00” to “VOL 50.”
4 Press SEL (select) to finish the setting.
Automatic clock adjustment
When shipped from the factory, the clock built in
this unit is set to be readjusted automatically
using the CT (Clock Time) data in the RDS
signal.
If you do not want to use automatic clock
adjustment, follow the procedure below.
• See also “Changing the general settings
(PSM)” on page 22.
1 Press and hold SEL (select) for more than
2 seconds so that one of the PSM items
appears on the display.
2 Press ¢ or 4 to select “AUTO
ADJ” (adjustment).
3 Press – to select “OFF.”
Now automatic clock adjustment is canceled.
4 Press SEL (select) to finish the setting.
To reactivate clock adjustment, repeat the
same procedure and select “ON” in step 3 by
pressing +.
Note:
You must stay tuned to the same station for more than
2 minutes after setting “AUTO ADJ” to “ON.”
Otherwise, the clock time will not be adjusted. (This is
because the unit takes up to 2 minutes to capture the
CT data in the RDS signal.)
Changing the display mode while
listening to an FM station
You can change the initial indication on the
display to station name (PS NAME), station
frequency (FREQ), or clock time (CLOCK) while
listening to an FM RDS station.
• See also “Changing the general settings
(PSM)” on page 22.
1 Press and hold SEL (select) for more than
2 seconds so that one of the PSM items
appears on the display.
2 Press ¢ or 4 to select
“DISPMODE” (display mode).
3 Press + or – to set to the desired indication
(“PS NAME,” “FREQ,” or “CLOCK”).
4 Press SEL (select) to finish the setting.
Note:
By pressing DISP (display), you can change the
display while listening to an FM RDS station only.
Each time you press the button, the following
information appears on the display:
• Then, the display goes back to the original
indication in several seconds.
Station name
(PS NAME)
Station frequency
(FREQ)
Programme type
(PTY)
Clock
(CLOCK)
EN10-16KS-FX742R[E_EX]f.p65 1/8/03, 5:08 PM15