Filter
Top Products
8
ENGLISH
3
Tune in to a station you want while
“M” (manual) is flashing.
• If you release your finger from the button,
the manual mode will automatically turns
off after 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 50 kHz intervals for FM
and 9 kHz intervals for AM—MW/LW) until
you release the button.
When an FM stereo broadcast is hard to
receive:
1 Press MODE to enter the
functions mode while listening to
an FM stereo broadcast.
2 Press MO (monaural), while still
in the functions mode, so that the
MO indicator lights up on the
display.
Each time you press the button,
the MO indicator lights up and
goes off alternately.
When the MO indicator is lit on the display, the
sound you hear becomes monaural but the
reception will be improved.
To tune in to stations of lower
frequencies
To tune in to stations of higher
frequencies
Storing stations in memory
You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM
band (FM1, FM2, and FM3).
1
Select the FM band (FM1 – 3) you
want to store FM stations into.
Each time you press the
button, the band changes as
follows:
2
Press and hold both buttons for
more than 2 seconds.
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2, or FM3).
These stations are preset in the number
buttons—No.1 (lowest frequency) to No.6
(highest frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.
MO (monaural) indicator
FM1 FM2 FM3 AM
“SSM” appears, then disappears when
automatic preset is over.
EN07-09KS-FX742R[E_EX]f.p65 1/8/03, 5:07 PM8