JVC KD-SX990 Car Stereo System User Manual


 
11
ENGLISH
Manual preset
You can preset up to 6 stations in each band
(FM1, FM2, FM3, and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band.
1
Select the band (FM1 3, AM) you
want to store stations into (in this
example, FM1).
Each time you press the
button, the band changes as
follows:
2
Tune in to a station (in this example,
of 88.3 MHz).
3
Press and hold the number button
(in this example, 1) for more than
2 seconds.
To tune in to stations of lower frequencies
To tune in to stations
of higher frequencies
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
A previously preset station is erased when a new
station is stored in the same preset number.
Preset stations are erased when the power supply to
the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset
the stations again.
Tuning in to a preset station
You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see Storing
stations in memory on pages 10 and 11.
1
Select the band (FM1 3, AM).
Each time you press the
button, the band changes as
follows:
2
Select the number (1 6) for the
preset station you want.
Note:
You can also use the 5 (up) or (down) button on
the unit to select the next or previous preset stations.
Each time you press the 5 (up) or (down) button,
the next or previous preset station is tuned in.
FM 1
(F1)
FM 2
(F2)
FM 3
(F3)
A M
FM 1
(F1)
FM 2
(F2)
FM 3
(F3)
A M
Selected band/preset number
and MEMO (memory)
appear alternately for a while.
EN09-11KD-SX9350_990[J]f.p65 12/27/02, 5:24 PM11