Filter
Top Products
11
ENGLISH
SCAN
Control dial
SEL
¢
4
RPT MO
SCAN Ÿ
Other convenient tuner functions
Scanning broadcast stations
When you press SCAN Ÿ (Scan/Dolby NR) while listening to the radio,
station scanning starts. (“SCAN” appears on the display.) Each time a
broadcast is tuned in, scanning stops for about 5 seconds (tuned frequency
number flashes on the display), and you can check what program is now
being broadcasted.
If you want to listen to that program, press the same button again to stop
scanning.
Selecting FM reception sound
When an FM stereo broadcast is hard to receive:
Press RPT MO (Repeat/Monaural) while listening to an FM stereo broadcast. The sound you
hear becomes monaural but reception will be improved.
To restore the stereo effect, press the same button again.
Changing the AM/FM channel intervals
When this unit is shipped from the factory, the channel intervals are set to 10 kHz for AM and
200 kHz for FM (so that the unit can be used in North and South America).
When using this unit in an area other than North and South America, change the channel
intervals by following the procedure below.
• AREA EU: Select this when used in an area other than North and South America.
• AREA US: Select this when used in North or South America.
1 Press SEL for more than 2 seconds.
One of the PSM items appears on the display.
2 If “PSM AREA” does not appear, press ¢
or 4 repeatedly until it appears.
3 Turn the control dial to the right.
“AREA EU” appears and the channel intervals are set to 9 kHz for AM and 50 kHz (for
manual tuning) / 100 kHz (for searching) for FM.
4 Press SEL again to finish the setting.
To reset to the factory setting, follow the above step 1 and 2, then turn the control dial to the
left in step 3 (“AREA US” appears on the display).
ANA
J
Lights up when receiving an FM broadcast in stereo.
RPT
MO
EN06-11.KW-XC770[J]/1 99.11.24, 3:26 PM11