Filter
Top Products
9
ENGLISH
Searching for a station manually:
Manual search
1
Select the band (FM1 – 3, AM).
Each time you press the
button, the band changes as
follows:
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to
an FM broadcast.
2
Press and hold ¢ or 4
until “M” (manual) starts flashing on
the display.
3
Tune in to a station you want while
“M” (manual) is still flashing.
• If you release your finger from the button,
the manual mode will automatically turns
off after 5 seconds.
• If you hold down the button, the frequency
keeps changing—in 50 kHz intervals
(87.5 MHz — 108.0 MHz for FM 1 and
FM 2), in 30 kHz intervals (65.00 MHz —
74.00 MHz for FM 3) and 9 kHz for AM—
MW/LW until you release the button.
When an FM stereo broadcast is hard to
receive
1 Press MODE to enter the
functions mode while listening
to an FM stereo broadcast.
2 Press MO (monaural), while
“MODE” is still flashing on the
display, so that “MONO”
appears on the display.
Each time you press the button,
monaural mode turns on and off
alternately.
When the MO indicator is lit on the display, the
sound you hear becomes monaural but the
reception will be improved.
To tune in to stations of lower frequencies
To tune in to stations of
higher frequencies
MO (monaural) indicator
FM1 FM2 FM3 AM
EN08-11_KD-G407[EE]f.p65 5/3/04, 2:26 PM9