Filter
Top Products
8
English
Notes:
The preset setting such as preset
channel and sound adjustment
may be erased in the following
cases:
• When you press POWER to
set it in the
—
OFF position.
• When you unplug the power
cord.
• When a power failure occurs.
CAUTIONS:
• Do not touch the power cord
with wet hands.
• Do not pull on the power cord
to unplug the receiver. When
unplugging the receiver, always
grasp the plug itself so as not
to damage the cord.
Connecting the Power Cord
Before plugging the receiver into an AC outlet, make sure that all connections have
been made.
1. Plug the power cord into an AC outlet.
2. Press POWER to set it in the
__
__
_ON position.
The STANDBY lamp lights up. A small amount of power is always consumed.
To shut off the power completely:
Press POWER to set it in the —OFF position.
Keep the power cord away from the connecting cables for the TV, VCR, and antenna.
The power cord may cause noise or screen interference. We recommend that you use a
coaxial cable to connect the antenna, since it is well-shielded against interference.
The difference between the POWER switch and the STANDBY/ON
button
• The POWER switch is the mains supply switch, allowing the receiver to connect
to the mains supply.
To shut off the power completely, press the POWER switch to set it in the —
OFF position.
• The STANDBY/ON button is a functional on/off (standby) switch, and does
not disconnect the receiver from the mains supply. A small amount of power is
consumed even in standby mode for receiver to accept signals from the remote
control.
Putting Batteries in the Remote Control
Before using the remote control, put the two supplied batteries in first. When using the
remote control, aim the remote control directly at the remote sensor on the receiver.
1. On the back of the remote control, press down on the battery cover and slide
it out.
2. Insert batteries. Make sure to observe the proper polarity: (+) to (+) and (–)
to (–).
3. Slide the cover.
If the range or effectiveness of the remote control decreases, replace the batteries. Use
two R6P (SUM-3)/AA (15F) type dry-cell batteries.
CAUTIONS:
Follow these precautions to avoid
leaking or cracking cells:
• Place batteries in the remote
control so they match the
polarity indicated: (+) to (+) and
(–) to (–).
• Use the correct type of batteries.
Batteries that look similar may
differ in voltage.
• Always replace both batteries at
the same time.
• Do not expose batteries to heat
or flame.
R6P (SUM-3)/AA (15F)
RX-554RBK(EE)_0118-001A_En01-23 98.1.30, 2:19 PM8