Filter
Top Products
ENGLISH
2
Attaching the front speakers to displays other than
the GD-V42XX series
Using the speaker brackets, you can attach the front speakers to the side of the display.
• For attaching the front speakers to the GD-V42XX series display, see page 4.
• In this section, the GM-P420 series displays are shown in the illustrations. The mounting screw positions of the
other displays are almost the same as those of the GM-P420 series, therefore you can attach the front speakers as
in the procedure below.
• Do not loosen the screws other than the mounting screws.
• Use only the screws already attached to the display.
1. Loosen the mounting screws on the back of the display.
Loosen the mounting screws with phillips screwdriver,
leaving a length of about 3 mm.
2. Attach the front speaker to the back of the display.
Hook the speaker bracket onto three mounting screws
through the screw holes (A), and slide it down.
3. Tighten the mounting screws firmly with phillips screwdriver.
• When moving the display, do not hold the speakers.
• The speakers are not of anti-magnetic type.
Do not place anything susceptible to magnetism, such as a video tape, nearby when setting the speakers.
Front speaker
Mounting screws
Front speaker
Front speaker
Mounting
screws
Mounting
screws
Screw hole (A)
EN_TS-C421SPGU_1.p65 03.3.20, 11:03 AM2