JVC TS-C421SPGU Car Speaker User Manual


  Open as PDF
of 7
 
ENGLISH
5
Bundling the speaker cords
You can bundle the speaker cords neatly with the supplied cord clamp, as illustrated.
• Stick the cord clamp after removing its protective seal. Give an amount of time before
bundling the speaker cords, or the cord clamp may be detached.
• If you are sticking the cord clamp to the back of the display, be careful not to block the
ventilation hole.
Specifications
• Power Handling Capacity : 3 W
• Impedance : 6 Ω
• Speaker : 9.5 cm x 1 cm
Direct Drive Speaker, two
• Dimensions
(W x H x D) : 43 mm x 640 mm x 43 mm
(Mass) : 0.7 kg (for each excluding the speaker bracket)
1. Fold the end of each speaker
cord.
Attach to the speakers
2. Press and hold the terminal
clamp.
3. Insert the speaker cord, and
release the finger from the
terminal clamp.
• Connect the cord with black stripes to the · (black) terminal and the other cord to the ª (red) terminal.
• Be careful that connection of the speaker cords to incorrect polarity terminals (ª and ·) degrades stereo
feeling and sound qualities.
When you connect the supplied speaker cord to the terminal clamp of the speakers, fold the end of each speaker
cord to avoid short-circuit.
Attach to the display
• Connect the cord with black stripes to the · (black) terminal and the other cord to the ª (red) terminal.
• Be careful that connection of the speaker cords to incorrect polarity terminals (ª and ·) degrades stereo
feeling and sound qualities.
1. Press and hold the terminal
clamp.
2. Insert the speaker cord, and
release the finger from the
terminal clamp.
Connecting the speaker cord
Speaker cord
Cord clamp
EN_TS-C421SPGU_1.p65 03.3.20, 11:03 AM5
 previous