Kenwood DDX7015BT Car Video System User Manual


 
62
REFERENCESREFERENCES
Maintenance
RCaution on cleaning the unit
Do not use any solvent (for example, thinner,
benzine, etc.), detergent, or insecticide. This may
damage the monitor or the unit.
Recommended cleaning method:
Gently wipe the panel with a soft, dry cloth.
RMoisture condensation
Moisture may condense on the lens inside the unit in
the following cases:
After starting the heater in the car.
If it becomes very humid inside the car.
Should this occur, the unit may malfunction. In this
case, eject the disc and leave the unit turned on for a
few hours until the moisture evaporates.
RHow to handle discs
When removing a disc from its case, press down
the center holder of the case and lift the disc out,
holding it by the edges.
Always hold the disc by the edges. Do not touch
its recording surface.
When storing a disc in its case, gently insert the
disc around the center holder (with the printed
surface facing up).
Make sure to store discs in their cases after use.
RTo keep discs clean
Dirty discs may not play correctly.
If a disc does become dirty, wipe it with a soft cloth
in a straight line from the center to the edge.
Do not use any solvents (for example,
conventional record cleaner, spray, thinner,
benzine, etc.) to clean discs.
RTo play new discs
New discs may have some rough spots around the
inner and outer edges. If such a disc is used, this unit
may reject the disc.
To remove these rough spots, rub the edges with
a pencil or ball-point pen, etc.
More information
RFile playback
Playing DivX files (for discs only)
This unit can play back DivX files with the
extension code <.divx>, <.div>, or <.avi>
(regardless of the letter case—upper/lower).
Audio streams should conform to MP3 or Dolby
Digital.
Files encoded in the interlaced scanning mode
may not be played back correctly.
The maximum bit rate for video signals (average)
is 8 Mbps.
Playing MPEG1/MPEG2 files
This unit can play back MPEG1/MPEG2 files with
the extension code <.mpg> or <.mpeg>.
The stream format should conform to MPEG
system/program stream.
The file format should be MP@ML (Main Profile at
Main Level)/SP@ML (Simple Profile at Main Level)/
MP@LL (Main Profile at Low Level).
Audio streams should conform to MPEG1 Audio
Layer-2 or Dolby Digital.
Playing JPEG/BMP/PNG files (for USB only)
This unit can play back picture files with the
extension code <.jpg>, <.jpeg>, <.bmp> or
<.png>.
This unit can play back files that are at 32 x 32 to
8192 x 7680 resolution.
It may take time to display the file depending on
its resolution.
This unit can play back baseline JPEG files.
Progressive JPEG files or lossless JPEG files cannot
be played.