Filter
Top Products
This function allows you to adjust the setting that is recalled
with the sound coordinate system, according to types of
speakers.
Press the SRC button repeatedly to select the standby mode.
"ALL OFF" is displayed when the standby mode is selected.
Press the AUD button to enter the mobile preset plan mode.
Press either the 4 or ¢ button to select the type of
speaker. The setting switches as follows.
Off / For the OEM speaker / For 6/6x9 in. speaker /
For 5/4 in. speaker
Press the AUD button to end the mobile preset plan mode.
•This setting can be made only when the Sound coordinate
system is on. (page 36)
•When you change the setting of type of speaker, the bass and
treble tone settings are returned to original levels.
NOTE
4
3
2
1
Mobile Preset
Recalling your sound settings:
Press a preset button (#1-6) except during the bass center
frequency, bass level, bass quality factor, bass extension,
treble center frequency, and treble level adjust mode.
This mode is available only when Sound coordinate system is on.
(page 36)
NOTE
•The settings you can preset are, bass centre frequency, bass
level, bass quality factor, bass extension, treble centre
frequency, and treble level.
Storing your sound settings:
Hold down a preset button (#1-6) for two seconds or more
except during the bass center frequency, bass level, bass
quality factor, bass extension, treble center frequency, and
treble level adjust mode.
•This setting can be made only when the Sound coordinate
system is on. (page 36)
NOTE
“VOL OFFSET” : Set the sound level of the each source selected
by adjusting the level difference between the
basic sound level and the required level.
Setting values: - 8 – 0
“NFpre Phase” : Adjust the phase for Non-Fading output.
Setting values: Normal (0°) / Reverse (180°)
•This mode is available only when the non-fading output function
is set to on. (KDC-8080R only)
•Not available during the Dual zone system is on.
NOTE
“LPF NFpre” : Adjust the frequency of the Low-pass filter for
Non-Fading output.
Setting values: 50 Hz / 80 Hz / 120 Hz / Through
•This mode is available only when the non-fading output function
is set to on. (KDC-8080R only)
•Not available during the Dual zone system is on.
NOTE
— 15 —