Filter
Top Products
Function Setting Operation
The basic operating procedure for using this
function is described below. The individual function
items are covered in the operating procedures.
1 Select the source
Press the [SRC] button.
Function items vary from source to source. For a list
of the function items. Refer to <Function Item List>
(Page 30).
2 Enter Function Setting mode
Press the [VOL] knob for at least 1 second.
”FUNCTION” is displayed.
3 Select your desired function item
Turn the [VOL] knob and press it when the
desired item is displayed.
Repeat the operation until your desired function
item is selected.
⁄
Press the [ ] button to return to the previous
item.
Example:
AUDIO CONTROL
[VOL] [VOL]
BASS BOOST
SUPREME SET
…
DETAILED SET
DETAIL SET
…
…
……
DISP SELECT
SETTINGS
In this manual, the above selection is indicated as
Select “AUDIO CONTROL” (“AUDIO CTRL”) >
“DETAILED SET” (“DETAIL SET”) > “SUPREME SET”.
(“ ”) encloses a display appearing on the KDC-BT30.
It is shown only if it differs from the one appearing
on the KDC-BT40U.
4 Make a setting
Turn the [VOL] knob to select a setting value,
and then press the [VOL] knob.
5 Exit Function Setting mode
Press the [ ] button for at least 1 second.
Before Using
Exit of the Demonstration Mode
Turn off the demonstration mode when you use it
for the first time after installation.
1 Press the [VOL] knob to quit the demonstration
mode when the messages “CANCEL DEMO” and
“PRESS”, “VOLUME KNOB” are displayed (approx.
15 seconds).
2 Turn the [VOL] knob to select “YES” and press the
[VOL] knob.
⁄
• The demonstration can be set or cancel using
<Demonstration Mode Setting> (page 18).
Common Operation
Power and source select
Turns the power ON by pressing the [SRC]
button.
Pressing [SRC] button each time switches
between sources.
Tuner (“TUNER”) ➜ USB* or iPod* (“USB” or
“iPod”) ➜ CD (“CD”) ➜ Auxiliary input (“AUX”) ➜
Standby (“STANDBY”)
Keeping pressing the [SRC] button at least 1
second turns the power OFF.
⁄
• * Function is KDC-BT40U only.
• When connection of the iPod is recognized, the source
display changes from “USB” to “iPod”.
• The source “CD” and “iPod” can be selected when each
source is ready to play.
Volume
Turning the [VOL] knob adjusts the sound
volume.
General operation
English
|
5