Filter
Top Products
12 ENGLISH
Listening to a disc
Before performing any operations...
Turn on the monitor to watch the playback picture. If you turn on the monitor, you can also
control playback of other discs by referring to the monitor screen. ( 16 – 20)
• Selects an appropriate color system (PAL/NTSC) for your monitor. ( 5, 6)
The disc type is automatically detected, and playback starts automatically (for DVD: automatic
start depends on its internal program).
~
]
Turn on the power.
Ÿ
If the current disc does not have any disc menu, all
tracks will be played repeatedly until you change the
source or eject the disc.
• When a disc is inserted, “IN” indicator lights up.
!
]
Starts playback if necessary.
If “
” appears on the monitor when pressing a button, the unit cannot accept the operation you
have tried to do.
• In some cases, without showing “ ,” operations will not be accepted.
• Do not attempt to insert a disc into the loading slot if another disc is already there.
• The unit can only play 12 cm discs. If you insert an 8 cm disc, it will get stuck inside and can cause the
unit to malfunction.
•
Discs with period of use:
DO NOT leave discs with a limited period of use in this unit. If you load
an already expired disc, you may not be able to remove it from this unit.
• If you turn off the power while listening to a disc, disc play will start automatically the next time you
turn on the power.
• If you change the source, playback also stops (without ejecting the disc). Next time you select the disc
source as the playback source, disc play starts from where it has been stopped previously.
• When removing a disc from the unit, pull it out horizontally.
Caution on volume setting:
Discs produce very little noise compared with other sources. Lower the volume before playing a
disc to avoid damaging the speakers by the sudden increase of the output level.
To check the Macrovision version
While listening to a DVD...
1
Press the control knob to enter Function Control settings.
2
Turn the control knob to select <SYS CTRL>, then press the control knob to confirm.
3
Turn the control knob to select <M/V FW VER>, then press the control knob.
The display shows the Macrovision version.
EN12-21_KDV-MP3346M[U]f.indd 12EN12-21_KDV-MP3346M[U]f.indd 12 11/23/09 2:15:25 PM11/23/09 2:15:25 PM