Filter
Top Products
English
10
Installation
Accessories
External view
......... Number of items
........1
1
........1
2
........1
3
External view
......... Number of items
........5
4
........2
5
(Ø4 x 12 mm)
(Ø4 x 16 mm)
Installation Procedure
1. To prevent short circuits, remove the key from the ignition and disconnect the · terminal of
the battery.
2. Make the proper input and output wire connections for each unit.
3. Connect the wiring harness wires in the following order: ground, ignition.
4. Connect the wiring harness connector to the unit.
5. Install the unit in your car.
6. Reconnect the · terminal of the battery.
7. Press the reset button. (See p. 3)
•This product is intended for use with 12V DC negative ground power only. Do not
connect it to any other power supply
•To prevent shorting, disconnect the battery wire from the negative terminal of the
battery during installation.
•Be sure to firmly stabilize this product. Do not install it in a location which is not
stable.
•Follow the installation and wiring procedures described in this manual. Improper
wiring or modified installation can not only result in malfunction or damage to the
unit but may also result in an accident.
•Do not install the unit in the following locations.
•A location which interferes with the operation of the air bag system.
•A location which is not made of plastic.
\ Installing on leather, wood or cloth may damage the surface.
•A location subject to direct sunlight, subject to the air from the air conditioner, or
subject to moisture or high temperature.
\This may cause deformation of the monitor unit.
2WARNING
IM_W_English_ver.5 02.12.20 1:38 PM Page 10