Filter
Top Products
11
•Be sure to use the supplied screws for installation.
Using screws longer than those supplied may destroy parts inside the unit causing it
to smoke. Using screws shorter than those supplied may cause the unit to come
looks from the installation bracket.
•If you are not going to install the unit using the supplied monitor stand, be sure to
use a commercially available monitor stand. (Mounting holes for such a stand are
located on the bottom of the monitor unit.)
• If your car's ignition does not come with an ACC position, connect the ignition
wires to a power source that can be turned on and off with the ignition key. If you
connect the ignition wire to a power source that receives a constant voltage supply,
as with battery wires, the battery may die.
• If the fuse blows, first make sure that the wires have not caused a short circuit,
then replace the old fuse with one with the same rating.
• Do not let unconnected wires or terminals touch metal on the car or anything else
conducting electricity. To prevent short circuits do not remove the caps from unused
terminals or from the ends of the unconnected wires.
•After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on
the car are working properly.
•Insulate unconnected wires with vinyl tape or other similar material.
•Thoroughly wipe away and dust or grease from the installation location using a cloth
which has been soaked in a neutral cleaning agent and wrung out. Attach the stand
after allowing the installation location to dry.
2CAUTION
IM_W_English_ver.5 02.12.20 1:38 PM Page 11