Filter
Top Products
9
Remote Control Function
<Provided with the KTC-V800N/KTC-V800P>
Do not set the remote on hot places such as above the
dashboard.
Loading and Replacing the Batteries
1. Use two "AA" batteries:
Slide the cover while pressing downwards to remove it
as illustrated.
2. Insert the batteries with the ª and · poles aligned
properly following the illustration inside the case.
Store unused batteries out of the reach of children. Contact
a doctor immediately if the battery is accidentally swallowed.
•The provided batteries are intended for use in operation checking, and their service life may
be short.
• When the remote controllable distance becomes short, replace both of the batteries with
new ones.
NOTE
2WARNING
2CAUTION
REMOTE CONTROL UNIT
RC-210
AME SP
SEEK
MODE V.SEL
CH. – CH. +
AV OUT
VOL
5
∞
SEARCH
M/S
BAND
4¢
Monitor Control Function
•V.SEL button
Each time you press V.SEL button to switch the monitor's picture.
• MODE button
Each time you press MODE button to switch the screen mode.
•AV OUT button
Each time you press AV OUT button to switch the AV output
mode.
TV Control Function
• BAND button
Each time you press the BAND button, the preset band
switches between the TV1 and TV2.
• SEARCH buttons
Press the ¢/CH.+ button to make increasing seeks.
Press the 4/CH.– button to make decreasing seeks.
• SEEK button
Each time you press the SEEK button, the seek mode switches
to auto 1, to auto 2 and to manual.
• AME button
You can automatically store all the receivable channels in the
band currently being looked to.
Select the band for auto memory entry.
Press the AME button.
Press the ¢/CH.+ button to start auto memory entry.
3
2
1
IM_W_English_ver.5 02.12.20 1:38 PM Page 9