Kenwood KMR-M308BT Car Satellite Radio System User Manual


 
4
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
GETTING STARTED
Set the initial settings
1
Press BSRC to enter STANDBY.
2 Press the volume knob to enter
[FUNCTION]
.
3
Turn the volume knob to make a selection (see the following table), then press
the knob.
4 Press and hold to exit.
To return to the previous setting item or hierarchy, press .
Default:
XX
AUDIO CONTROL
SWITCH PREOUT
REAR
/
SUB-W
: Selects whether rear speakers or a subwoofer are connected to
the line out terminals on the rear (through an external amplifier).
SP SELECT OFF
/
5/4
/
6 × 9/6
/
OEM
: Selects according to the speaker size (5inches or
4inches, 6×9inches or 6inches) or OEM speakers for optimum performance.
TUNER SETTING
PRESET TYPE
NORMAL
: Memorizes one station for each preset button in each band (FM1/
FM2/ FM3/ AM). ;
MIX
: Memorizes one station for each preset button, regardless
of the selected band.
SYSTEM
KEY BEEP
ON
:Activates the keypress tone.;
OFF
:Deactivates.
SOURCE SELECT
PANDORA SRC*
ON
:Enables PANDORA in source selection.;
OFF
:Disables.
( 8)
IHEART SRC*
ON
:Enables IHEARTRADIO in source selection.;
OFF
:Disables.
( 9)
BUILT-IN AUX
ON
:Enables AUX in source selection.;
OFF
:Disables.
( 8)
F/W UPDATE
UPDATE SYSTEM/ UPDATE BT
F/W UP xx.xx
YES
:Starts upgrading the firmware.;
NO
:Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
* For
KMM-BT308U
/
KMR-M308BT
.
3
Cancel the demonstration
When you turn on the power (or after you reset the unit), the
display shows: “CANCELDEMO”
“PRESS” “VOLUMEKNOB”
1 Press the volume knob.
[YES]
is selected for the initial setup.
2 Press the volume knob again.
“DEMOOFF” appears.
For
KMR-M308BT
,
[DEMO OFF]
is selected initially.
Set the clock
1
Press the volume knob to enter
[FUNCTION]
.
2
Turn the volume knob to select
[CLOCK]
, then press the knob.
3
Turn the volume knob to select
[CLOCK ADJUST]
, then press the knob.
4
Turn the volume knob to make the settings, then press the knob.
Day Hour Minute
5
Turn the volume knob to select
[CLOCK FORMAT]
, then press the
knob.
6
Turn the volume knob to select
[12H]
or
[24H]
, then press the knob.
7
Press and hold to exit.
To return to the previous setting item or hierarchy, press .
While in clock display screen...
Press and hold DISP SCRL to enter clock adjustment mode
directly.
Then, perform step
4 above to set the clock.
1
2
EN_KMM_BT308U_KN_2.indd 4EN_KMM_BT308U_KN_2.indd 4 8/11/2013 3:46:54 PM8/11/2013 3:46:54 PM