Filter
Top Products
— 43 —
Refer to the section "Removing the faceplate (page 10)" and
then reattaching the faceplate.
Never insert the taptite screws (ø2 × 6 mm) in any other screw
holes than the one specified. If you insert it in another hole, it
will contract and may cause damage to the mechanical parts
inside the unit.
2CAUTION
3
Attaching Steering Remote Control (Optional for
the KRC-778R/778RV)
Attach the operation section and the light emitting section of the
Steering Remote Control as shown above.
Be sure to attach them to positions that can ensure proper
operation.
• Clean dirt and oil from the positions where the Steering
Remote Control sections are to be attached.
• If the attached position is cold, warm it before attaching.
• The position should be selected so that the product does not
come in the way of steering operation.
• Do not attach anything on the surface of a steering wheel
incorporating an air bag.
• Before finally affixing the transmitter, check various angles to
find an orientation that provides faithful operation.
2CAUTION
Mounting Example
6
9
8
7
Locking the faceplate to the unit
If you want to lock the faceplate to the unit so that it does not
fall off, follow the directions below.
Refer to the function "Removing the faceplate" (page 10) and
remove the faceplate.
Insert the provided screw into the hole at the centre of the
bottom side of the faceplate which you have removed from
the unit.
2
1
Accessory5
Locking the faceplate to the unit
■