Kenwood LZ-612IR Car Video System User Manual


  Open as PDF
of 11
 
8
|
LZ-612IR
Accessories
①
DC Cord ..........1
②
Monitor Cable ..........2
③
RCA Cable ..........2
④
Remote Control Cable ..........1
⑤
Template ..........1
⑥
Mounting Bracket ..........2
⑦
Removal Tool ..........1
⑧
Mounting Screw (Ø4x16) ..........2
Accesaries/Installation Procedure
Installation Procedure
1. Topreventshortcircuits,removethekeyfromthe
ignition and disconnect the terminal of the
battery.
2. Make the proper input and output cable
connections for each unit.
3. Connectthewiringharnesswiresinthefollowing
order: ground, ignition.
4. Connectthewiringharnessconnectortotheunit.
5. Installtheunitinyourcar.
6. Reconnect the terminal of the battery.
7. Presstheresetbutton.(page2)
WARNING
• Thisproductisintendedforusewith12VDCnegative
groundpoweronly.Donotconnectittoanyotherpower
supply.
• Topreventshorting,disconnectthebatterycablefromthe
negative terminal of the battery during installation.
• Besuretofirmlystabilisethisproduct.Donotinstallitina
location which is not stable.
• Followtheinstallationandwiringproceduresdescribedin
this manual. Improper wiring or modified installation can
not only result in malfunction or damage to the unit but
may also result in an accident.
•Mountingandwiringthisproductrequiresskillsand
experience.Forsafety'ssake,leavethemountingandwiring
work to professionals.
• Ifyourcar’signitiondoesnotcomewithanACCposition,
connect the ignition wires to a power source that can be
turned on and off with the ignition key. If you connect the
ignition wire to a power source that receives a constant
voltage supply, as with battery wires, the battery may die.
• Ifthefuseblows,firstmakesurethatthewireshavenot
caused a short circuit, then replace the old fuse with one
with the same rating.
• Donotletunconnectedwiresorterminalstouchmetal
onthecaroranythingelseconductingelectricity.To
prevent short circuits do not remove the caps from unused
terminals or from the ends of the unconnected wires.
• Aftertheunitisinstalled,checkwhetherthebrakelamps,
blinkers, wipers, etc. on the car are working properly.
• Insulateunconnectedwireswithvinyltapeorothersimilar
material.
• Thoroughlywipeawayoilandotherdirtfromthe
installation surface.
Pleaseavoidinstallationonunevensurfaces.
• DonotinstalltheHideawayUnitunderthecarpet.
Otherwise heat build-up occurs and the unit may be
damaged.
CUT OUT ON DOTTED LINE
(The cut-out size needs to be adjusted
depending on the installation of the monitor.)
LZ-612IR TEMPLATE
INSERT REMOVAL TOOL
INSERT REMOVAL TOOL
LZ-612IR REMOVAL TOOL GUIDE
1-LZ-612IR_ENG_0405.indd 8 2010-04-05 �� 5:11:58
 previous next