Filter
Top Products
KRAMER ELECTRONICS LTD.
8
10 TAKING CARE OF YOUR MACHINE
Do not locate your machine in an environment where it is susceptible to dust or
moisture. Both of these may damage the electronics, and cause erratic operation
or failure. Do not locate your machine where temperature and humidity may be
excessive. Doing so may also damage the electronics, and cause erratic operation
or failure of your machine. Do not clean your machine with abrasives or strong
cleaners. Doing so may remove or damage the finish, or may allow moisture to
build up. Take care not to allow dust or particles to build up inside unused or
open connectors.
11 TROUBLESHOOTING
NOTES
Please note that if the output signal is disturbed or interrupted by very strong external
electromagnetic interference, it should return and stabilize when such interference ends. If
not, turn the power switch off and on again to reset the machine.
If the following recommended actions do not result in satisfactory operation, please
consult your KRAMER Dealer.
11.1 Power and Indicators
Problem Remedy
No Power
! Confirm that power connections are secured at the
machine and at the receptacle. Make sure the receptacle
is active, outputting the proper voltage.
! If there is still no power use a Philips screwdriver to
remove screws on both sides of the machine and release
the panel.
! Locate the fuse inside your machine. Confirm that the
fuse is good by looking for the wire connected between
the ends of the fuse. If this wire is broken, replace fuse
with another, with the same rating.
! Install cover and tighten the Philips screws.