Filter
Top Products
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting a VM-2HDCP 1:2 DVI Distributor
8
5.1.1 Acquiring/Changing the EDID
You can work with the default EDID or acquire or change an EDID via one
of the connected outputs. Use the EDID Setup button to acquire the output
EDID information.
To acquire or change the EDID of a new output display:
1. Connect the power supply.
The ON LED lights.
2. Connect the new output display device.
3. Press and hold the EDID button for more than three seconds and release.
The INPUT LED blinks and the OUT 1 LED and OUT 2 LED blink
alternately.
4. Press the EDID button again when the appropriate OUT LED lights, that is,
to copy the EDID from the display connected to the DVI:
OUT 1 connector, press the EDID button when the OUT1
LED is on
OUT 2 connector, press the EDID button when the OUT2
LED is on
In either case, the VM-2HDCP copies the EDID from the display. If no
display is connected to the selected DVI output, the default EDID will be
chosen.
Note that during the EDID setup, the respective OUT LED blinks. When that
output is connected, that OUT LED illuminates
5.1.2 Acquiring the Clone EDID
To acquire the Clone EDID, do the following
1
1. Connect the new output display device (for example, to OUT 1).
:
2. Disconnect the power supply.
3. Reconnect the power supply while pressing the EDID button.
The ON LED lights and the OUT 1 and OUT 2 blink alternately.
4. Release the EDID button when the OUT 1 LED blinks.
The Clone EDID is stored in the non-volatile memory when the OUT 1
LED ceases to blink.
1 This example refers to OUT 1. The same applies for OUT 2 if the acceptor is connected to OUT 2