Filter
Top Products
Press any button except the EJECT and OPEN button to turn on the
unit, press PWR button hold for more than 0.5 seconds to turn off
the unit.(After switching on the ACC POWER first time for 3 seconds,
can only turn on the unit)
12. PRESET STATION [ 1-6 ] AND TOP/CDP, INT, RPT, RDM BUTTONS.
A].To memorize the current frequency, press any one of the six
preset buttons hold for more than 2 seconds.
B].To recall the preset memory, press one of the preset buttons
[1-6].
C).In CDP mode, press TOP/CDP button to pause CDP playback,
press it again to resume CDP playback. Press it hold for more
than about 0.5 seconds to play the first track of the disc.
D).In CDP mode, press INT button to play the first 10 seconds part
of each track, press it again to stop INT mode and retain playing
the track currently selected.
E).In CDP mode, press RPT button to play the current track
repeatedly. Press it again to cancel this mode.
F).In CDP mode, press RDM button to play the track in random
order. Press it again to cancel this mode.
13. MODE BUTTON
Press it to select RADIO or CDP mode.
14. INFRA-RED REMOTE CONTROLLING SENSOR
9. POWER BUTTON
11.MUTE BUTTON
Press the button to eliminate or resume the sound immediately.
To resume the sound immediately, can also press MODE, BAND, +,
-, (LOUD) and SEL button.
10.STEREO/MONO BUTTON
Press it repeatedly to select STEREO or MONO sound mode.
7 4
SPEAKER CONNECTION
++
++
++
++
YELLOW
ANTENNA PLUG
MEMORY B+
BLACK(GND)
RED (B+)
RCA LINE OUT
RED R
WHITE L
FRONT
REAR
RIGHT
SP
BLUE AUTO ANT
FRONT
WHITE
WHITE/BLACK
GREEN/BLACK VIOLET/BLACK
GRAY/BLACK
GRAY
VIOLETGREEN
REAR
LEFT
SP
NOTE:
1. In spite of having any kinds of speaker system, must use 4 ohms
impedance of speaker to reduce the distortion during high volume level.
2. Prohibit to make the conductors of auto antenna and ground
touch with each other.
FUSE
FUSE
7 A
0.5 A
AUX LINE IN
RED R
WHITE L
This radio is set to USA frequency by factory, if European
frequency is required please flip the frequency step switch on
the side of the unit.
After the switchover of the frequency switch, the frequency convert
function will not be valid until the RESET button has been pressed.
(The RESET button is in the rear facet of the front panel)
USA EUROPE
IMPORTANT: