Filter
Top Products
6
206-4261
Commercial Mode Overview
This document describes how to set up LY560M Pro:Centric
®
TVs for Commercial Mode operation.
LG commercial TV functionality is based on “ownership” of the Channel Map; that is, the Channel Map
resides in the TV’s CPU or Protocol Translator Card (PTC) or it resides externally from the TV (i.e., in a
device from the solution provider).
These TV models are capable of Free-To-Guest (FTG) Mode operation via the TV CPU. Alternatively, the
TV can be configured for Pass-through Mode (default). When in Pass-through Mode, these TV models also
allow external control via the TV’s MPI port.
Setup Checklist
Note: This document provides information specific to Commercial Mode operation. Refer to the Owner’s
Manual for detailed information on TV installation and hardware and cable connections.
Installation
__ Unpack TV and all accessories.
__ Install batteries in the Installer Remote.
__ Install TV on VESA mount or stand.
Note: It may be advisable to make all cable
connections before installing on VESA mount
or stand, as appropriate.
Hardware Connections
__ Install any additional hardware as
appropriate to your institution, LAN, etc.
Cable Connections
__ Make all rear jack panel connections, as
appropriate.
Commercial Mode Setup
__ Complete appropriate procedures as described
in this document for Commercial Mode operation.
Pass-through Mode
This mode allows you to configure individual TVs for Pro:Centric and/or FTG Mode operation or create a
Master TV Setup for cloning purposes. This mode also allows external control via the MPI port on the TV
rear jack panel.
There are two methods for configuring stand-alone TVs in Pass-through Mode: either using the Express
Script Installer Menu Wizard or the Custom Master TV Setup procedure as described in this document.
Express Script Installer Menu Wizard
The Express Script Installer Menu Wizard guides you through the process of setting up a TV that is in a
factory default state. Its customization of TV features and Installer Menu items is limited to those that are
essential to most hospital TV viewing applications. See “Express Script Installer Menu Wizard” on pages
12 to 17 for detailed information.
Note: While the Express Script Installer Menu Wizard enables you to set up TVs in lieu of cloning, you can
also use an Express Script TV Setup for TLL cloning purposes, if desired. However, note that TV setup
menu customization via the Express Script Installer Menu Wizard is limited to Channel Menu options.
Custom Master TV Setup
Unlike the guided process above, the Custom Master TV Setup procedure enables you to create a
customized Master TV Setup for cloning purposes for TVs that are to remain in Pass-through Mode. Use
the Installer Remote to congure Installer Menu items as required for TV operation and set up TV features
(Channel, Picture, Audio, etc.). See “Custom Master TV Setup” on pages 31 to 35 for detailed information.