Filter
Top Products
39
206-4118
Reset Clone After Static Shock
After replacing exhausted batteries, or if the Clone
Programmer behaves strangely after a static shock, use a
paper clip or similar instrument inserted through the small
hole marked RESET to activate the internal reset switch
and restore normal operation. After a reset, check the real-
time clock setting. It may be necessary to reset the Clone
Programmer clock from a TV containing the correct time.
Note
The LT2002 Programmer is designed to be used with TVs
containing the 221-01006 and later processors. Use with
earlier TV sets may give unpredictable results. Processors
used before the 221-01006-04 have a limited screen dis-
play capability. They cannot display entire screens as
shown in the quick setup instructions accompanying the
LT2002 Clone Programmer. Use the printed menu illustra-
tions on the quick setup sheet supplied with the Clone
Programmer as an aid to making your programming choic-
es. (Although the menus are not all displayed, the clone
functions all operate normally.)
• After cloning operations are complete, unplug the LT2002 from the TV.
• If the TV does not display a picture on the TV (blank screen) after a few seconds, just change channels.
Clone Programmer Troubleshooting
Clone Programmer
Clone copies setup in
less than 30 seconds.
Not enough time to copy entire TV setup. Press RESET on Clone Programmer, redo Teach/Learn.
(Teach/Learn should take a minimum of one (1) minute.)
Remote does not operate
clone.
Wrong Installer Remote. Only use an LG Installer Remote to operate Clone
Programmer with TV.
LED does not blink. MPI cord not connected. Connect MPI cord properly, and ensure good connection.
TV not turned ON. TV must be powered ON for Clone Programmer to work.
Weak batteries. Install four (4) fresh AA high-quality alkaline batteries.
Clone menu hard to read. Weak signal. Connect TV to a reliable analog channel signal source.
No time set. Time not available. Set time on a TV, and copy time to Clone Programmer.
Clone not working. Clone Programmer problem. Try a different LT2002 Clone Programmer.
Reset the Clone Programmer.
Clone scans channels
more than once.
Clone should only scan channels once. Try cloning again.
Master and Other TVs
Cloning did not work. Procedure interrupted. Wait until procedure complete message is displayed.
Different TV models. Cloning is only possible with identical model TVs.
Step(s) omitted or not performed. Refer to pages 20 to 23, and make sure all tasks were
performed.
Clone time disappeared. Batteries were removed. Batteries must remain installed to retain time settings.
New setup not present. TV not reset. Disconnect newly-cloned unit from power for five (5) sec-
onds.
Reference: LT2002 Cloning Procedure Troubleshooting
Warning: Do not use the LT2002 while any PPV card is
installed in TV, or the Clone Programmer and the PPV
card will be damaged.
Symptom Possible Cause(s) Possible Solution(s)