Filter
Top Products
12
206-4214
Automated Installation Routine Wizard (Cont.)
Auto Configuration
Processing Pro:Centric Configuration.
Step 2 may take up to 15 min(s).
Please wait...
Step 1 Detecting the type of Pro:Centric network
Step 2 Locating the Pro:Centric Server
Step 3 Determining the Pro:Centric mode
Step 4 Downloading the application files
Step 5 Downloading the maintenance files
Step 6 Saving the Pro:Centric configuration
Warning - Do not remove AC power or the signal cables during these steps
10%
RF
In Progress
:
:
:
:
:
:
Prev.
Use the Up/Down arrow keys on the Installer Remote to select/
highlight Pro:Centric Auto from the Automated Installation
Routine Wizard Welcome screen. Then, press OK.
The Pro:Centric Auto Conguration will proceed with a series of
automated steps to congure the TV for Pro:Centric operation
and to download the Pro:Centric application and E-Z Installation
data. The Auto Conguration screen (see example at right)
shows overall progress, as well as the progress and/or values
for each of the individual installation steps. Note that some steps
may require up to 15 minutes.
When the Pro:Centric Auto Conguration is complete, the wizard
exits, and the TV will turn OFF.
Pro:Centric Auto Conguration
When selected, this option enables the TV to use a search algorithm to automatically determine
the type of Pro:Centric network, the (RF) Data Channel, and the Pro:Centric Application Mode.
The TV then looks for the Pro:Centric application and maintenance (E-Z Installation) les to
download.
Note: If the Pro:Centric server conguration is IP or if you intend to use the Pro:Centric server for
remote management only of TV E-Z Installation (splash screen, configuration, and/or firmware)
data downloads, use the “Pro:Centric Manual” option described below.
Pro:Centric Manual Conguration
If the Pro:Centric server conguration is RF, and you already know the settings (i.e., Data Channel
and Pro:Centric Application Mode) that need to be congured in order for the TV to connect to the
Pro:Centric server, you may streamline the setup process by entering this data manually. Also, if
the Pro:Centric server conguration is IP or if the Pro:Centric server is to be used solely for remote
management of E-Z Installation data downloads, this procedure enables you to specify the appro-
priate settings.
1. Use the Up/Down arrow keys on the Installer Remote to select/highlight Pro:Centric Manual
from the Automated Installation Routine Wizard Welcome screen. Then, press OK.
In the rst Manual Conguration Screen (see examples on following page), you will be able to
congure the appropriate Pro:Centric settings. Use the Up/Down arrow keys on the Installer
Remote to navigate between elds.
Note: Select the “Back” button from the Manual Conguration screen or press the key on the
Installer Remote, if desired, to return to the Welcome screen.
2. In the Pro:Centric Mode eld, use the Left/Right arrow keys to select the appropriate
Pro:Centric Application Mode—GEM, FLASH, HTML, or Conguration Only.
Note: For remote management only, select the Pro:Centric Mode “Conguration Only”
option to only search for TV E-Z Installation data downloads. Pro:Centric application data will
not be downloaded.
3. Refer to the appropriate subsection on the next page, depending on the Pro:Centric server
conguration, to complete the remaining elds.
(Continued on next page)