Filter
Top Products
33
206-4214
Teach Master TV Setup to Target TV
1. Turn ON the Target TV.
The next step depends on whether the Automated Installation Routine
Wizard appears on the screen when you turn ON the TV:
• If the wizard is displayed, the TV is already in the required factory
default state. Use the Up/Down arrow keys on the Installer
Remote to select Exit from the Welcome screen, and press OK to exit
the wizard. Then, go to step 3.
• Otherwise, ensure the Target TV is in Pass-through Mode. Then,
continue with step 2.
2. Use the Installer Remote to access the Target TV Installer Menu (see
“Accessing the Installer Menu” on page 19 for further information). Set
Installer Menu item 117 FACT DEFAULT to 001, and press OK. When
the value changes back to 0, press OK again to exit the Installer Menu.
Note: This step restores factory default settings on the TV, which will
in turn re-activate the Automated Installation Routine Wizard. Use the
Up/Down arrow keys on the Installer Remote to select Exit from the
Welcome screen. Then, press OK to exit the wizard.
3. Tune/set the TV to an analog or digital channel or Aux input (ideally the
same source tuned for 2-5-5 + MENU Mode during the Master TV Setup
procedure).
4. Plug the USB memory device with the .tll le into the Target TV USB IN
port.
5. Press MENU SETTINGS on the Installer Remote to display the TV
setup menus. Use the arrow navigation keys to select/highlight the
Option menu icon, and then press the number “7” key a total of seven
times to display the USB Download Menu.
6. Use the Up/Down arrow keys to select Teach To TV (TLL), and then
press OK.
7. Use the Up/Down arrow keys to select the Master TV Setup you want to
install, and then press OK. Note: Filenames identify the TV and the TLL
version (see example at right).
Teaching status will be shown on a progress bar in a new window.
When the Teaching process is complete, the USB Download menu will
reappear on the screen.
8. When Teaching is done, press on the Installer Remote to exit the
USB Download Menu, remove the USB memory device from the Target
TV, and turn OFF the TV.
9. After a few seconds, turn ON the TV, and verify that the Master TV
Setup is now resident on the Target TV.
Note: When you turn it back ON, the TV will tune according to the setting
of Installer Menu item 004 STRT CHANNEL (Start Channel). If a Start
Channel is specified, the TV will tune to that channel; otherwise, the TV
will return to the last channel tuned.
USB Cloning Procedures (Cont.)
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV (TLL)
Teach To TV (TLX)
Previous OK
Teach To TV (TLL)
Previous OK
xxLT770H-UA00001.TLL
Teach To TV
UPDATING...
Do not remove the USB from the port!
Do not unplug!
50%
!