Filter
Top Products
64
206-4235
Remote Jack Pack Setup
RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item 093
RJP AVAILABLE appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE
to 1). See Installer Menu detailed descriptions for further information.
TV Connections
Make these connections ONLY after Master TV Setup and TV cloning procedures are
complete.
Refer to the figure below, and connect the RJ-45 Control cable from the RJP cable bundle to the RJP
INTERFACE port on the TV’s rear jack panel. Then, connect HDMI, RGB, and Composite Video/Audio
connectors, as applicable, for the cable bundle.
Reference: Remote Jack Pack / TV Connections & Setup
RGB IN (PC)
ANTENNA/
CABLE IN
SPEAKER OUT
LINE OUT
RESET
UPDATE
RJP
GAME CONTROL
/ MPI
RS-232C
(SERVICE & EXT POWER)
LAN
AUX LAN
/
DVI
IN
1
(ARC)
..........
2
..........
/ DVI IN
3
..........
AUDIO IN
(RGB/DVI)
AV IN
OPTICAL AUDIO OUT
SERVICE ONLY
TV-LINK CFG
HDMI/DVI IN 1
Connect HDMI connector
from RJP cable bundle.
RJP INTERFACE
Connect RJ-45 Control
cable from RJP cable
bundle.
AUDIO/VIDEO IN
Use A/V adapter cable provided with TV,
and connect Composite Video/Audio
connectors from RJP cable bundle.
(Composite Video on legacy RJP only.)
093 RJP AVAILABLE 001
RGB IN (PC)
Connect RGB connector
from RJP cable bundle
(legacy RJP only).