Filter
Top Products
11
206-4124
FMA-LG101 Installation (Cont.)
FMA-LG101 Installation Notes
• The AC outlet providing power must be installed near the FMA-LG101 and be easily accessible.
• The FMA-LG101 should be installed in a restricted access location.
FMA-LG101 Rack Installation
Refer to the FMA-LG101 diagrams on page 10, and complete the following steps to install the FMA-
LG101 in the equipment rack.
1. As shipped, the FMA-LG101 rack mount brackets are attached inward, covering the front panel of the
FMA-LG101 unit. Detach and then re-attach the rack mount brackets to the FMA-LG101 as shown in
the diagrams on the previous page.
2. Mount the FMA-LG101 in the equipment rack.
3. Complete all connections as indicated in the FMA-LG101 Rear and Front Panel Connections table
below.
4. Plug the power supply for the FMA-LG101 in to an AC outlet (or the rack power strip, if applicable), and
then connect the 12V DC output to the FMA-LG101.
5. Wait at least 30 seconds for the FMA-LG101 to power ON and obtain network settings from a DHCP
server or load its default network settings.
6. Congure the FMA-LG101 as described on the pages that follow.
FMA-LG101 Rear and Front Panel Connections
Port Name Connection
Rear Panel RF OUT Connect the 50 MHz low pass filter and coaxial RF cable from the RF
distribution system combiner. (The 50 MHz low pass filter protects RF
channels 2 and 3 from any potential RF interference produced by the
FMA-LG101.)
RF IN Not applicable; connect the 75 ohm terminator.
DC 12V Connect the 12V DC power supply shipped with the FMA-LG101.
Front Panel ETHERNET Make the appropriate connection based on the system setup:
• Network Ethernet connection: Connect an Ethernet straight-through
cable (not supplied) from the network. The FMA-LG101 must be
connected to a network with a DHCP server before power is applied.
• Direct Ethernet connection: Connect the supplied Ethernet crossover
cable from a PC.
Refer to “FMA-LG101 Ethernet Connection/Network Options” on the
next page for further information.