Filter
Top Products
206-4124
14
FMA-LG101 Conguration (Cont.)
FMA-LG101 Conguration using the FTG Device Conguration Application Software
1. Launch the FTG Device Configuration Application (v5.0.0 or higher). *
2. Click Configure and then FMA from the FTG Device Conguration Application menu bar to access the
FMA Configuration Utility (see screen sample on page 9). Then, set the FMA Utility’s IP address, update
the FMA-LG101 configuration, and configure the FMA clock and broadcast rate as described below.
Set the FMA Utility’s IP Address
The IP address specified in the FMA IP Communication section at the bottom right of the screen must be
set to the FMA’s current IP address (see “FMA Configuration Prerequisites” on previous page).
a. If you need to modify the FMA Utility’s IP address, double-click anywhere within the IP Address field.
b. In the pop-up window, type the appropriate IP address, and then click OK. Or, to restore the IP
address to the default value (10.20.1.120), click Default and then OK.
Update the FMA-LG101 with an FMA Configuration File
a. Use the current contents of the FMA Configuration List, or click the Open button above the FMA
Configuration List window to open an existing FMA Configuration (.fma) file.
Note: When opening an existing FMA file, reconfirm the FMA Utility’s IP address, since the FMA file
when saved, had an IP address associated with it.
b. Click the Write button in the FMA Configuration Transfer command section of the screen (below the
FMA Configuration List window) to transfer the current contents of the FMA Configuration List to the
FMA-LG101.
c. Once the system processes the request, a pop-up report message indicates success. Click OK to
close the pop-up window and continue.
Set the FMA Clock
The facility for setting the FMA clock is located on the right side of the FMA Conguration Utility screen.
Date and time must be set on the PC running the FTG Device Configuration Application prior to an
attempt to set the FMA clock.
a. If desired, click the Auto DST checkbox. When checked, the FMA’s clock automatically observes
Daylight Saving Time.
b. Click the Set Clock button to set the date and time of the FMA to the PC’s date and time.
c. In the Date & Time pop-up window (displays a snapshot of the PC's current date and time), confirm
the settings, and then click Yes to synchronize the FMA’s clock with the PC's clock.
d. Once the system processes the request, a pop-up report message indicates success. Click OK to
close the pop-up window and continue.
Set the FMA Broadcast Rate
The facility for setting the FMA broadcast rate is located on the right side of the FMA Configuration Utility
screen. The broadcast rate determines the interval, in seconds, at which to repeat the broadcast of the
date & time, the FTG Channel Map, and the FTG Installer Menu profile(s). (FMA-LG101 factory default
broadcast rate is 300 seconds.)
(Continued on next page)
* If the configuring PC is running Windows Home Premium software, you must run the FTG Device Configuration
Application as an administrative user in order to communicate with and configure the FMA-LG101.