Magnadyne M9900CDS Car Stereo System User Manual


 
Speciality Features
Display Button: The factory default setting is clock display priority. Push the
DISPLAY button at any time will display the radio frequency, CD track,
AUX 1 or AUX 2.
Note: In the Sirius mode the factory default setting is Sirius channel dis-
play priority. Push the DISPLAY button at any time to display the
CN-NAME, SONG TITLE, ARTIST, CATEGORY and Clock. If clock is cho-
sen the time will be displayed for approximately 5 seconds then revert to
displaying the Category.
DISP
EQ
5
INTRO
BAND W-B
DIS
LOUD
MUTE
EQ
ENTER
Reset Button:
The radio panel or LCD display may fail to function normally
due to the vehicle’s battery condition, and may require resetting the radio
microprocessor if:
• The vehicle has been “jump started” from a dead battery condition.
• The vehicle battery becomes very low and is quick-charged.
• The vehicle battery is removed and replaced.
Should this condition occur, simply press and release the RESET button
on the radio panel using the tip of a ball point pen. This will reset the
radio microprocessor to the original factory settings. After pressing the
RESET button you should recheck to see if the radio functions normally.
All station programming should remain, but you will have to reset the
clock. Should the LCD display area show any abnormal error code, please
refer to the trouble shooting guide and solution chart below.
11
Error Code Problem Description Possible Remedy
ERR 1 Mechanism Problem Unknown mechanical 1. Eject the disc and try another.
problem with the CD 2. Press the reset button.
mechanism. 3. Replace the unit.
ERR 2 TOC Reading Error Laser can not read the 1. Insert a different disc.
CD disc table of 2. Check disc for excessive scratches.
contents. 3. Check disc for dirt and fingerprints.
Clean disc and reinsert.
ERR 3 Error from High The temperature of the Reduce the temperature inside the vehicle
Ambient Temp. mechanism is too high and try to play a CD at a later time.
to play CDs without
damaging them.
ERR 4 Laser Focus Error Laser pickup fails to 1. Insert a different disc.
focus and read the disc. 2. Check disc for excessive scratches.
3. Check disc for dirt and fingerprints.
Clean disc and reinsert.
4. Press the reset button.
ERR 6 CD Loading Error The loading mechanism 1. Push the reset button.
is damaged. 2. Replace the unit.
ERR 7 Laser Servo Error Laser servo is not 1. Press the reset button.
functional. 2. Replace the unit.
M9900CDS-UM 4/26/06 14:21 Page 11