Filter
Top Products
3
Monitor Features and Controls
1. LCD Screen
2. IR Sensor: Receives signal from the
remote control.
3. LED Power Indicator:
A red LED indicates the vehicle’s ignition
is “On” and the monitor is in the “stand-
by” mode. When the vehicle is put into
reverse or the turn signals are used the
camera’s image will automatically appear
on the display. Note: The cameras can
not be manually selected in this mode.
A green LED indicates the power button
on the monitor has been pressed and the
ignition is “On”. The camera’s images
can manually be selected to appear by
using the SEL button. The video in jack
is also operational.
LED is off: The monitor has no function.
4. Power Button: Press this button to turn
the unit "On" or "Off".
Note: The ignition key must be in the
“On” position.
5. Brightness Button (Decrease): Press
this button to decrease the
screen’s
brightness.
Note: When the menu is displayed press
this button to adjust the selected menu
item.
6. Brightness Button (Increase): Press this
button to increase the screen’s brightness.
Note: When the menu is displayed, press
this button to adjust the selected menu
item.
7. CH- Button (Menu Item Selection):
Press this button to select a menu item
when a menu is displayed.
8. Menu Button: Press this button to select
a desired menu screen.
9. SEL: Press this button to select a video
sources (CAM1, CAM2, CAM3 and DVD).
Note 1: When the left turn signal is acti-
vated CAM1 (left side view camera) is
selected automatically.
Note 2: When the right turn signal is
activated CAM2 (right side view camera)
is selected automatically.
Note 3: When the vehicle is put into
reverse CAM3 (rearview camera) is
selected automatically.
10. Video Input Jack
11. Speaker: The speaker is automatically
activated only when the vehicle is put
into revers
e.
Note: The rear camera must have a built-
in microphone for proper operation.
21
4
7
8
9
3
10
11
5 6