Filter
Top Products
Additional information13
64
En
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
Important
• If the system does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
General
Problem
Remedy
The power does not
turn on.
• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear
panel. This could cause the system to shut off automatically.
No sound is output
when a function is
selected.
• If you’re using the line input, make sure the component is connected
correctly (see
Connecting auxiliary components
on page 53).
• Press
MUTE
on the remote control to turn muting off.
• Adjust the
VOLUME
.
• If you’re using the TV input, make sure you’ve selected the RCA audio input
(see
Switching the TV audio input from SCART to RCA
on page 57).
No image is output
when playing discs.
• Make sure the TV is connected correctly (refer to the Setup Guide).
•
Not applicable to the European model –
Reset the video output to interlace
(see
Video Output settings
on page 49).
No sound from
surround or center
speakers.
• Refer to
Setting the channel levels
on page 46 to check the speaker levels.
• Check that you haven’t selected the
STEREO
sound mode (see
Listening in
surround sound
on page 24).
• Connect the speakers properly (refer to the Setup Guide).
Can’t operate the
remote control.
• Replace the batteries (refer to the Setup Guide).
• Operate within 7 m, 30° of the remote sensor on the front panel (refer to the
Setup Guide).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• You won’t be able to use the remote sensor of this unit with the
CONTROL
IN
jack of this unit connected to the
CONTROL OUT
jack of your plasma
display. You can use the remote sensor of the plasma display (even in
standby) as long as the power isn’t switched off.
XV-DV323.book 64 ページ ２００４年１月１３日 火曜日 午後７時５７分