Filter
Top Products
4
Unpacking and placement
Unpack your Nº28 Preamplifier and keep all packing materials for
future transport. Locate and remove all accessory items from the
cartons.
Carefully inspect the product for damage and flaws. If you find any,
see your Mark Levinson dealer immediately.
Place the Nº28 as close as possible to the source equipment, thus
keeping interconnect cabling as short as possible. It may be placed
on a shelf or in a cabinet where it's convenient to operate.
A two-meter DC cable is provided to connect the PLS-228 to the Nº28.
This allows you to place the PLS-228 so that it won't induce hum in the
Nº28 and other sensitive components. Other associated equipment
should also be placed so that it doesn't induce hum in the Nº28 and
other sensitive components.
Be sure to allow 3 to 4 inches of clearance above both the Nº28 and
the PLS-228, to allow heat dissipation through air circulation.
Mechanical drawings are included in this manual to facilitate special
installations and custom cabinet work (see "Dimensions").
For your protection, review "Important safety instructions" before you
install your Nº28.
Unpacking
Placement
Ventilation
PRECAUTION